Telephone Controlled Display System

This circuit can be for making a Telephone controlled display system.Here we use a seven segmented display system associated with a control circuit.The control signal come from the telephone which is decoded and used to operate the display system which displays the number corresponding to signal.The circuit also provides a Beep Sound during operation. 

Dual-tone multiple-frequency (DTMF) receiver IC is commonly used in telephone equipment. One common DTMF receiver is Holtek HT9170 used in electronic communication circuits. The Holtek HT9170 series comprises DTMF receivers integrated with digital decoder and bandsplit filter functions. All HT9170 series ICs use digital counting techniques to detect and decode all the 16 DTMF tone pairs into a 4-bit code output.The circuit can also be used in quiz contests and by visually- or hearingimpaired people. It can be used to call a maximum of nine different persons. The circuit is built around DTMF receiver IC HT9170, BCD-to-7-segment decoder/driver 7447, quad 2-input OR gate and common-anode display. Simple melody generator IC UM66 is used to produce melody sound in the loudspeaker through Darlington-pair transistors (T1 and T2).The tone pair DTMF generated by pressing the telephone key is converted into binary values internally in the IC. The binary values are indicated by the glowing of LEDs at the output of IC1.  LEDs connected via resistors R15 through R18 at pins 11 through 14, respectively. LED1 indicates the LSB and LED4 indicates the MSB

·        BCD-to-7-segment decoder/ driver 7447, whose outputs are connected to the common-anode display for displaying the pressed number on the telephone connected in parallel to the circuit.  Gates N1 and N2 to activate the call bell.

    Here is how the circuit works: Connect the telephone and the circuit in parallel to the telephone line. Connect 6V to the circuit. When you press switch S1, DIS1 shows ‘0.’ Lift the handset off the cradle and dial a number, say, ‘1.’ The output of IC1 becomes A3A2A1A0 = 0001. LED1 glows, the display shows ‘1’ and the call bell sounds.To stop the call bell, put the receiver on the cradle and press switch S1 momentarily. Now DIS1 shows ‘0’ and LED1 stops glowing.For calling other numbers, follow the same procedure: Lift the handset off the cradle and press the desired number (0 through 9). The respective LED will glow, the number will be displayed on DIS1 and the call bell will sound. Now put the handset on the cradle and press S1 momentarily to stop the call bell.